bcd . 002 8 4 _ aa_may - 3 1 - 2013 1 www.power - one.com data sheet ? instrumentation ? li ghting ? industrial applications ? applied computing ? renewable energy ? test and measurement ? robotics ? wireless communications abc 201 series 200 w ac/dc ? 160 w convection cooled ? - 20 to 50 deg c full load operation ? 3 x 5 x 1.5 (76.2 x 127 x 38.1 mm) ? no minimum load required ? 12 v fan & 5 v standby outputs ? inhibit, power good and fail signals ? conducted emi en 55022 - b, fcc part 15 level b ? ite safety agency approvals ? rohs compliant features applications
abc 201 series 2 www.power - one.com data sheet technical dat a : input parameter description/condition input voltage range universal input 90 - 264 vac 120 - 390 vdc input frequency range 47 - 63 hz input surge current 230 vac (cold start) 65 a max. safety ground leakage current 230 vac 300 a max input current 120 vac @ 200 w 230 vac @ 200 w 2.4 a 1.2 a output parameter description/condition voltage adjustment v1 3% transient response main output 50 to 100% load change, 50 hz, 50% duty cycle, 0.1a / usec < 10%, recovery time < 5 ms over voltage protection v1 110 to 150% rated max over current protection rated output current 110% typical short circuit protection automatic recovery set point tolerance 1% rise time < 100 msec ordering information product family volts (vdc) max load convection (1) max load 300 lfm (1) minimum load (a) ripple & noise (4) connector total regulation abc20 1 - 1005g 5.0 26.0 a 26 a 0 1% jst 2.5% abc201 - 1t05g 5.0 26.0 a 35 a 0 1% screw terminal 2.5% abc20 1 - 1012g 12 13.33 a 16.67 a 0 1% jst 2.5% abc201 - 1t12g 12 13.33a 16.67 a 0 1% screw terminal 2.5% abc20 1 - 1015g 15 10.66 a 13.33 a 0 1% jst 2.5% abc201 - 1t15g 15 10.66 a 13.33 a 0 1% screw terminal 2.5% abc20 1 - 1024g 24 6.66 a 8.33 a 0 1% jst 2.5% abc201 - 1t24g 24 6.66 a 8.33 a 0 1% screw terminal 2.5% abc201 - 1030g 30 5.33a 6.67a 0 1% jst 2.5% abc201 - 1t30g 30 5.33a 6.67a 0 1% screw terminal 2.5% abc20 1 - 1048g 48 3.33 a 4.17 a 0 1% jst 2.5% abc201 - 1t48g 48 3.33 a 4.17 a 0 1% screw terminal 2.5% vfan (all models) 12 0.5 a 0.5 a 0 20% v s/b (all models) 5 1.0 a 1.0 a 0 5%
bcd . 002 8 4 _ aa_may - 3 1 - 2013 3 www.power - one.com data sheet notes: 1. combined power from main output, vfan and vs/b should not exceed total power rating. 2. fan output tolerance is 20%. when v1 full load, vfan needs 20 ma load to be wi thin regulation specification. peak current for fan output is 1 a. 3. ripple is 2% up to 20 % load an d less than 1% above 20% load. output noise measurement is made with a 20 mhz bandwidth using a 6 twisted pair, terminated with a 10 uf tantalum capacitor in parallel with a 0.1 uf ceramic capacitor. 4. specifications are for nominal input voltage, 25 c and max load unless otherwise stated. 5. air flow over length of supply recommended (either direction) for forced air rating. 6. class 1 models have earthing tab j4. class 2 models ( - 2 suffix) have no earthing tab. 7. specifications may change without notice. 8. warranty 2 years. general specifications parameter description/condition hold up time 120 vac 10 msec 230 vac 10 msec mtbf >200 khrs bellcore tr - 332 switching frequency pfc con verter variable 35 to 250 khz, 90 khz typical resonant converter v ariable 35 to 250 khz, 90 khz typical isolation voltage input to output: min 4242 vdc weight 325 g (0.72 lbs) environmental parameter description/condition operating temperature - 20 to 70 c see derating charts below altitude operating 10,000 ft. non - operation 40,000 ft. storage temperature - 40 to +70 c humidity 95% non - condensing conducted emissions: en55022, fcc part 15 level b radiated emissions en55022, fcc part 15 level b to be controlled in end system static discharge en61000 - 4 2, 3, 4, 5 level 3 harmonic current en61000 - 3 - 2, class d signals parameter description/condition power good signal ttl signal goes high after main output is in regulation band. delay is 0.1 to 0.3 sec. power fail signal ttl signal goes low 1 msec advance before output goes out of regulation due to mains failure remote on / off to turn - on power supply short j3 pin 4 to pin 6 (psu is shipped in this configuration) remote sense compensates for 200 mv cable drop safety parameter description/condition en / ul / csa en60950 - 1+a12:2011, iec60950 - 1 2 nd +a1 2009, csa - 22.2 no 60950 - 01 - 07+ a1, ul60950 - 1 - 2011
abc 201 series 4 www.power - one.com data sheet figure 1 output power vs. temperature figure 2 dimension drawing (top and side view) mechanical input = j1 earthing tab = j4 dc output = j2 signals & aux power= j3 pin 1: ac neutral pin 2: ac line molex: 19705 - 4301 pin 1 = rtn pin 2 = rtn pin 3 = rtn pin 4 = vout pin 5 = vout pin 6 = vout pin 1 = + remote sense pin 2 = vfan (+12 v) pin 3 = - remote sense pin 4 = inhibit pin 5 = vs/b (5 vdc) pin 6 = return (signal) pin 7 =power fail pin 8 = power good mating connector: molex: 09 - 50 - 3031 pins: 08 - 50 - 0106 mating connector: molex: 190030001 mating connector: jst vhr - 6 m, pins: svh - 41t - p1.1. awg #20 to #16 mating connector: molex: 22 - 01 - 2087, pins: 08 - 50 - 0113 copyright ? 2010 power - one inc. all rights reserved. words and logos that are identified as trademarks and/or service marks are, unless noted otherw ise, the trademarks and service marks of power - one inc. in the u.s. and other countries. all other product or service names are the property of their respective holders. power - one products are protected under numerous u.s. and foreign patents and pending applications, maskwork rights, and copyrights. power - one reserves the right to make changes to any products and services at any time without notice. power - one assumes no responsibility or liability arising out of the application or use of any information, product, or service described herein except as expressly agreed to in writing by power - one inc. nuclear and medical applications - power - one products are not designed, intended for use in, or authorized for use as critical components in life su p- port systems, equipment used in hazardous environments, or nuclear control systems without the express written consent of the respective divisional president of power - one, inc. technical revisions - the appearance of products, including safety agency certifications pictured on labels, may change depending on the date manuf a c- tured. specifications are subject to change without notice.
|
